MEN Micro (Ambler, PA) has
announced a low power, rugged
SBC that incorporates flexible I/O
for demanding graphics
environments. Using an Intel
Atom processor running at
1.6 GHz, the new SC27 is
compact, powerful, and able
to withstand harsh environ-
ments. Features include:
A maximum resolution of 1280 x 768 pixels.
A fanless SBC that dissipates up to 7 W.
A temperature sensor to monitor and control the display.
An operational temperature range from -40° to +85°C.
Up to 2 GB of DDR2 SDRAM memory, with an
800 MHz bus frequency.
16 Mbits of boot Flash.
An mSATA slot with transfer rates of up to 3 Gbit/s as well as a
microSD slot via USB.
Wireless communication via WiFi, WiMAX, GSM/GPRS, UMTS,
HSDPA, and LTE.
A Fast Ethernet port via an M12 connector, 2 USB ports, a GPS,
and an RS232 or RS422/485 interface.
Additional I/O functions via MEN Micro’s universal SA Adapters.
An internal 10 to 50.4 V wide range power supply, either 24 VDC
or 36 VDC nominal.
A Power over Ethernet (PoE) source of 37 to 57 V, 48 VDC
nominal, depending on application requirements.
Compact Power Supplies
The MPU-400M series, available now from MicroPower Direct
(Stoughton, MA), is a family of compact 400 W AC/DC power
supplies that are certified to EN 60601 3rd edition. These power
supplies offer a unique combination of high power, safety features,
robust performance, and compact construction. Features include:
Factory set outputs of 12, 24, or 48 VDC.
A peak output power to 700 W,
reinforced insulation, and an
I/O isolation of 4,000 VAC.
Protection for over load,
over voltage, over
temperature, and short
Interface signals for Power On,
Power Good, AC Fail, and a Remote On/Off.
A MTBF greater than 100 khours.
An optional “current share”
feature that allows up to 4 units to be connected together.
A compact 8 x 5 x 1.6” U-Channel Chassis.
An operational temperature range from 0° to +70°C (ambient).
Efficient Mounting Schurter (Santa Rosa, CA) has developed a new IEC C20 appliance inlet for efficient printed circuit board mounting. The GSP4 appliance inlet can be easily sand- wiched between split enclosures and tested before it is installed in the equip- ment. Stabilizing posts provide quick snap-in assembly to the PCB. Features include: PCB terminals for L, N, and E. A 6. 3 x 0.8 mm quick connect or solder tab.
An optional back cover for protection against accidental contact.
ENEC and CCC approvals for 16 A / 250 VAC.